How To Access The Programming Mode; Key Menu - Coffee Selection - LaCimbali S39 TE Utilisation Et Installation

NOTE ONLY if the item "Customer Progr." is set on "YES"
and the item "Program. block" is set on "NO".
To access programming press the PRG
following message will appear on the display:
CUSTOMER PROG.
KEY MENU
Access to menus: press a selection key.
Access and modi cation of sub-menus: Use the "+"
(30) and "-" (31) keys to position the cursor (black
line) on the desired line, then press the PRG
KEY MENU
Type
M
M
Use the "+" (30) and "-"
message or number.
Press one of the coffee dispensing keys (32) (the relative
led will remain on). The following message will appear on
the display:
KEY MENU
Type
M
M
The following coffee selection parameters can be
- repetition (it represents the number of distributions of
- water dose
- coffee dose

19. How to access the programming mode

(29
(29) key.
+
1 coffee
(31) keys also to modify the

19.1 Key menu - Coffee selection

+
1 coffee
Note
turns into " " or a slide bar with minimum and maximum
settings appears:
M
-
The icons below appear in alternating order in the lower
part of the display:
Exiting the programming menu
- Press the
- Press the RES
and exit the menu
If the "Customer Progr." is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
- water start (represents the number of pulses of the
volumetric doser before the activation of the additional
of 1. If the value set is higher than the water dose, the
- Additional water
- LED Colors the color of the LEDs during dispensing,
- MANUAL MOVE (see chapter "Grinders manual handling").
The dose for making a cup of coffee can be composed of
grounds taken from both hoppers, which has the advantage
of less time needed for grinding.
Example
technical programming
coffee dose M1 02.0
coffee dose M2 05.5
26 EN
+
(24) key to leave settings unchanged
customer programming
coffee dose M1 01.0÷03.0
coffee dose M2 04.5÷06.5
+