Check Control Messages; Messages In Explicit Mode - LaCimbali S39 TE Utilisation Et Installation

The check-control messages are divided into two groups:

1. Messages in explicit mode:

2. Messages in code:
When there are several errors, their representation is timed, passing in succession on the display.
MESSAGE POSSIBLE CAUSES: when the message is visualized
Machine cold 1. This message will appear on the display every time the
machine is turned on until the service boiler pressure falls
below the pre-set working pressure. When the service
boiler reaches the pre-set pressure, the message auto-
matically disappears.
2. Whether the service boiler cannot reach the set working
pressure because of a problem, this message will be inte-
grated with the message in code identifying the component
that caused that problem.
No coffee One or all hoppers are almost empty.
(SX/DX...)
Grounds This message means that the coffee ground drawer is full.
drawer full
(coffee-based drinks) before the machine is blocked and
the following message is then displayed.
Empy The machine counts in decreasing order the pre-set max-
drawer imum grounds number. This message means that that
value run out. The machine is blocked and no coffees bev-
erages can be delivered.
Grounds This message always appears when the back side of the
drawer drawer is not in the right position.
removed
boiler
Service This message is displayed when the machine requires the
needed periodic maintenance intervention. In order to eliminate tem-
porary the message, keep pressed RES key for approximately
8 seconds. The message will reappears in the successive
relighting of the machine with the main switch.
No milk The message is displayed only if the machine is connected
to a 'Fresh Milk' and indicates that there is no milk in the
refrigerator tank.

14. Check Control Messages

they position on the last line at the bottom of the Display (5). They are cancelled
on each new cycle and then appear again if the cause that generated them returns
these appear in the top right-hand corner with the following syntax: Exxx
where:
- E
- xxx appresents the error code of the unit.
Messages in explicit mode
21 EN
VERIFICATIONS
2. Consult the technical manual and refer
problem
Fill in the hopper with coffee beans.
Empty the drawer to reset the counter
or wait until when the machine will dis-
play the message 'empty drawer'.
Consult the technical manual to program
the number of grounds to the attainment
of which the message will be visualized.
Remove the coffee grounds drawer.
Empty the drawer and replace it in the
correct position. Close the panel. Dur-
ing this operation the message 'Groun.
Draw. Removed' will be displayed.
If this message appears when the draw-
er is inserted, check the drawer is cor-
rectly positioned.
This operation is performed automati-
cally and requires no action by the user.
This operation does not impede the hot
water delivery.
Contact the authorized technical depart-
ment. The message will be displayed
until the service will be carried out. (Re-
fer to the Technician's Manual).