Changing The Brightness; Saving Power In Standby Mode; Enabling The Ir Repeater Function (When You Cannot Control The Tv) - Sony HT-NT3 Mode D'emploi

While holding INPUT, press VOL –,
VOL + and VOL – in sequence.
"LOCK" appears in the front panel
display.
You can only operate the system by
using the remote control.
To cancel, while holding INPUT, press
VOL –, VOL + and VOL – in sequence.
"UNLCK" appears in the front panel
display.

Changing the brightness

You can change the brightness of the
front panel display and blue LED
indicator.
Press DIMMER repeatedly.
You can select "OFF", "DIM1" or "DIM2".*
* The brightness for "DIM1" and "DIM2"
settings are the same.
Note
The front panel display is turned off when
"DIM2" is selected. It turns on
automatically when you press any buttons,
then turns off again if you do not operate
the system for about 10 seconds. However,
in some cases, the front panel display may
not turn off.
Saving power in Standby
Mode
Check that you have made the following
settings:
 [Bluetooth Standby] is set to [Off]
(page 25).
 [Control for HDMI] in [HDMI Settings] is
set to [Off] (page 26).
 [Quick Start/Network Standby] is set
to [Off] (page 27).
 [Remote Start] is set to [Off] (page 28).
Enabling the IR repeater
function (when you
cannot control the TV)
When the Bar Speaker obstructs the
remote control sensor of the TV, the TV
remote control may not work. In that
case, enable the IR repeater function of
the system.
You can control the TV with the remote
control of the TV by sending the remote
signal from the rear of the Bar Speaker.
Note

Be sure to check that the remote control
of the TV cannot control the TV, then set
[IR-Repeater] to [On]. If it is set to [On]
when the remote control can control the
TV, appropriate operation may not be
obtained, because of the interference
between the direct command from the
remote control and the command via the
Bar Speaker.

On some TVs, this function may not work
correctly. In this case, place the Bar
Speaker slightly further away from the TV.
1
Press HOME on the remote control
of the system.
The home screen appears on the TV
screen.
35
US