Sony HT-NT3 Mode D'emploi page 25

[Bluetooth Settings]
 [Bluetooth Mode]
You can enjoy contents from remote
device by using this system or listen to
sound from this system by using other
device such as headphones.
[Receiver]: This system is in receiver
mode which enables it to receive and
output audio from the remote device.
[Transmitter]: This system is in
transmitter mode which enables it to
send audio to the BLUETOOTH receiver
(such as headphones). If you switch the
input of the system, "BT TX" appears in
the front panel display.
[Off]: The BLUETOOTH power is turned
off and you cannot select the [Bluetooth
Audio] input.
Note
You can connect to a remote device by
using One-touch listening function even
though you have set [Bluetooth Mode] to
[Off].
 [Device List]
Display a list of paired and detected
BLUETOOTH receivers when [Bluetooth
Mode] is set to [Transmitter] (page 25).
 [Bluetooth Standby]
You can set the [Bluetooth Standby] so
that the system can be turned on by a
BLUETOOTH device even when the
system is in standby mode. This
function is only available when you set
[Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: The system turns on automatically
when you establish a BLUETOOTH
connection from a paired BLUETOOTH
device.
[Off]: Off.
Note
If you set [Quick Start/Network Standby] to
[Off] and [Bluetooth Standby] to [On], the
system can be turned on by a BLUETOOTH
device, but BLUETOOTH connection fails.
 [Bluetooth Codec - AAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: Enable AAC codec.
[Off]: Disable AAC codec.
Note

You can enjoy high quality sound if the
AAC is enabled. In case you cannot listen
to AAC sound from your device, select
[Off].

If you change the [Bluetooth Codec - AAC]
setting when a BLUETOOTH device is
connected, the codec setting is only
reflected after the next connection.
 [Bluetooth Codec - LDAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]: Enable LDAC codec.
[Off]: Disable LDAC codec.
Note
If you change the [Bluetooth Codec - LDAC]
setting when a BLUETOOTH device is
connected, the codec setting is only
reflected after the next connection.
25
US