Connecting With A Wireless Network - Sony HT-NT3 Mode D'emploi

Enter the values for [Subnet Mask],
[Default Gateway], [Primary DNS] and
[Secondary DNS], then press
Connecting with a
wireless network
Setting up a wireless LAN
connection
Before performing network
settings
When your wireless LAN router (access
point) is Wi-Fi Protected Setup (WPS)-
compatible, you can easily set the
network settings with the WPS button.
If not, you will be required to select or
enter the following information. Check
the following information in advance.

The network name (SSID)* of the
wireless LAN router/access point

The security key (password)** for the
network
* SSID (Service Set Identifier) is a name
that identifies a particular access point.
** This information should be available
from a label on your wireless LAN
router/access point, from the operating
instructions, from the person who set up
your wireless network, or from the
information provided by your Internet
service provider.
1
Follow Steps 1 to 4 of "Setting up a
wired LAN connection" (page 16).
2
Press / to select [Wireless
Setup(built-in)], then press
A list of available SSIDs (access
points) appears on the TV screen.
3
Press / to select the network
name (SSID) you want, then press
.
The security setting display appears
on the TV screen.
4
Enter the security key (WEP key,
WPA/WPA2 key) using the
software keyboard. Use ///
and
numbers, then select [Enter] to
confirm the security key.
The system starts connecting to the
network. For details, refer to the
messages that appear on the TV
screen.
If using a fixed IP address
Select [New connection registration] in
step 3, select [Manual registration], then
follow the on-screen instructions to
select [Specify IP address]. The IP
address input display appears on the TV
screen.
Follow the on-screen instructions to
enter the value for [IP Address], then
press
Enter the values for [Subnet Mask],
[Default Gateway], [Primary DNS] and
[Secondary DNS], then press
Note
The security setting display in step 4 does
not appear if your network has not been
secured by encryption (using the security
key).
.
.
to select the characters/
to confirm the values.
.
17
US