Network Connection - Sony HT-NT3 Mode D'emploi

 The types and number of devices
that can be controlled by the
"BRAVIA" Sync feature are
restricted by the HDMI CEC
standard as follows:
 Recording devices (Blu-ray Disc™
recorders, DVD recorders, etc.): up
to 3 devices
 Playback devices (Blu-ray Disc™
players, DVD players, etc.): up to
3 devices (including this system)
 Tuner-related devices: up to
4 devices
 Audio system (receiver/
headphones): up to 1 device
(including this system)

Network connection

The system cannot connect to the
network.
 Check the network connection
(page 16) and the network settings
(page 28).
Wireless LAN connection
You cannot connect your PC to the
Internet after [Wi-Fi Protected Setup
(WPS)] is performed.
 The wireless settings of the router
may change automatically if you
use the Wi-Fi Protected Setup
function before adjusting the
settings of the router. In this case,
change the wireless settings of your
PC accordingly.
The system cannot connect to the
network or the network connection is
unstable.
 Check if the wireless LAN router is
on.
 Check the network connection
(page 16) and the network settings
(page 28).
46
US
 Depending on the usage
environment, including the wall
material, radio wave reception
conditions, or obstacles between
the system and the wireless LAN
router, the possible communication
distance may be shortened. Move
the system and the wireless LAN
router closer to each other.
 Devices that use a 2.4 GHz
frequency band, such as a
microwave, BLUETOOTH, or digital
cordless device, may interrupt
communication. Move the system
away from such devices, or turn off
such devices.
 The wireless LAN connection may
be unstable depending on the
usage environment, especially
while using the BLUETOOTH
function of the system. In this case,
adjust the usage environment.
The wireless router you want is not
shown in the wireless network list.
 Press BACK to return to the previous
screen, and try [Wireless
Setup(built-in)] again. If the wireless
router you want is still not detected,
select [New connection registration]
from the network list, then select
[Manual registration] to input a
network name (SSID) manually.
BLUETOOTH device
BLUETOOTH connection cannot be
completed.
 Make sure that the blue LED
indicator is lit (page 48).
 Make sure the BLUETOOTH device
to be connected is turned on and
the BLUETOOTH function is
enabled.
 Move the BLUETOOTH device closer
to the Bar Speaker.