Mounting The Bar Speaker On A Wall - Sony HT-NT3 Mode D'emploi

3
Attach the stand to the Bar
Speaker by matching the "" on
the stand to the "" on the Bar
Speaker.
4
Repeat step 2 and 3 to attach the
stand for the other side.
Mounting the Bar
Speaker on a wall
You can mount the Bar Speaker on a
wall.
Note

Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.

Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.

Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.

When you use the HDMI IN 3 jack of the
wall-mounted Bar Speaker, connect the
swivel-type High Speed HDMI Cable with
Ethernet.
38
US
1
Stand
2
3
Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
More than 30 mm (1 3/16 in)
5.2 mm
(7/32 in)
10 mm
(13/32 in)
Fasten the screws to two studs in
the wall.
The screws should protrude by
8 mm to 9 mm (11/32 in to 3/8 in).
8 mm to 9 mm
(11/32 in to
3/8 in)
Hang the Bar Speaker on the
screws.
Align the holes at the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.
4 mm
(3/16 in)
726 mm
(28 5/8 in)