Further Settings For The Wireless System - Sony HT-NT3 Mode D'emploi

2
Press  to select
upper right corner, then press
3
Press / to select [System
Settings], then press
4
Press / to select [IR-Repeater],
then press
5
Press / to select [On], then
press .
Further settings for the
wireless system
You can make further settings for the
wireless system by using the [Wireless
Sound Connection] settings.
1
Press HOME.
The home screen appears on the TV
screen.
2
Press  to select
upper right corner, then press
3
Press / to select [System
Settings], then press
4
Press / to select [Wireless
Sound Connection], then press
The [Wireless Sound Connection]
display appears.

[Secure Link] (page 36)

[RF Band] (page 37)
36
US
[Setup] at the
.
.
[Setup] at the
.
Activating wireless
.
transmission between
specific units
[Secure Link]
You can specify the wireless connection
to link the Bar Speaker to the subwoofer
using the Secure Link function.
This function can help prevent
interference if you use multiple wireless
products or your neighbors use wireless
products.
1
Select [Wireless Sound
Connection] in [System Settings]
(page 36).
2
Press / to select [Secure Link],
then press
3
Press / to select [On], then
press
4
Press SECURE LINK on the rear of
the subwoofer.
Proceed to the next Step within a
few minutes.
.
5
Press / to select [Start], then
press
To return to the previous display,
select [Cancel].
.
6
After the message [Secure Link
setting is complete.] appears,
press
The subwoofer is linked to the Bar
Speaker and the on/standby
indicator on the subwoofer turns
orange.
If the message [Cannot set Secure
Link.] appears, follow the on-screen
messages.
.
.
.
.