Saving Power In Standby Mode; Mounting The Bar Speaker And The Surround Speakers On A Wall - Sony HT-RT3 Mode D'emploi


Sound may be interrupted when the
sampling frequency or the number of
channels of audio output signals from
the playback equipment is switched.

If the connected equipment is not
compatible with copyright-protection
technology (HDCP), the image and/or
the sound from the HDMI OUT jack of
this system may be distorted or may
not be output. In such a case, check
the specifications of the connected
equipment.
Saving power in standby
mode
Check that you have made the following
settings:
 "CTRL" in "HDMI>" is set to "OFF"
(page 18).
 "BTSTB" in "BT >" is set to "OFF"
(page 18).
Mounting the Bar
Speaker and the
Surround Speakers on a
wall
You can mount the Bar Speaker and the
Surround Speakers on a wall.
Notes

Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely in the wall beam. Install the
speakers on a vertical and flat wall where
reinforcement is applied.
22
US

Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.

Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes at the
rear of the Bar Speaker or
Surround Speakers.
More than 30 mm (1
5 mm
7
( / in)
32
9.5 mm
3
( / in)
8
Hole at the rear of the speakers
2
Fasten the screws in the wall.
The screw should protrude as
illustration.
For the Bar Speaker
600 mm (23
6 mm to
7 mm
1
( / in to
4
9
/ in)
32
3
4 mm ( / in)
16
3
/ in)
16
5
/ in)
8