Settings And Adjustments; Using The Setup Display - Sony HT-RT3 Mode D'emploi

Settings and Adjustments

Using the setup display

You can set the following items with the menu.
Your settings are retained even if you disconnect the AC power cord (mains lead).
1
Press MENU to turn on the menu in the front panel display.
2
Press BACK///ENTER repeatedly to select the item and press ENTER to
select the setting you want.
3
Press MENU to turn off the menu.
Menu list
The default settings are underlined.
Menu items
"LVL >" "SUR.L"/"SUR.R"
(Level) (Surround left/right
speaker level)
"ATT"
(Attenuation
settings – Analog)
"DRC"
(Dynamic range
control)
"TTONE"
(Test tone)
"SPK >" "PLACE"
(Speaker) (Speaker
placement)
"SUR.L"/"SUR.R"
(Surround left/right
speaker distance)
Function
"0.0 dB": Adjusts the sound level of the Surround
Speakers from –6.0 dB to +6.0 dB (0.5 dB interval).
Note
Be sure to set "TTONE" to "ON" for easy adjustment.
Distortion may occur when you listen to a device
connected to the ANALOG IN jack. You can prevent
distortion by attenuating the input level on the system.

"ON": Attenuates the input level. The output level will
decrease at this setting.

"OFF": Normal input level.
Useful for enjoying movies at low sound volume. DRC
applies to Dolby Digital sources.

"ON": Compresses sound in accordance with the
information contained in the content.

"OFF": Sound is not compressed.

"ON": The test tone is output from each speaker in
sequence.

"OFF": Turns off the test tone.

"STDRD": Select this setting if you install the Bar Speaker
and the Surround Speakers in standard position.

"FRONT": Select this setting if you install the Bar Speaker
and the Surround Speakers in front.
"3.0 M": Adjusts the distance from the seating position to
the Surround Speakers from 1.0 meter (3.3 feet) to
6.0 meters (19.7 feet).
17
US