Connections; Connecting To A Tv; S-Video Connection - Sony DAV-SB100 Mode D'emploi

Connections

Connecting to a TV

Make one of the following connections, depending on
the capabilities of your existing equipment.
Tips
Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the DVD Receiver. Use one of the connec-
tions described below.
Please refer to the manuals of your TV, VCR or other
devices as necessary to make the best connections.
– Make sure the DVD Receiver is connected directly to
the TV. Select the correct AV input on your TV.
– Do not connect your DVD Receiver to TV via your
VCR. The DVD image could be distorted by the copy
protection system.
Video connection
Connect the MONITOR OUT VIDEO jack on the DVD
Receiver to the video in jack on the TV using the video
cable (V).

S-Video connection

Connect the S-VIDEO OUT jack on the DVD Receiver
to the S-Video in jack on the TV using the S-Video
cable (S).
Component Video (Color Stream
connection
Connect the COMPONENT VIDEO OUT jacks on the
DVD Receiver to the corresponding in jacks on the TV
using the component (C).
Progressive Scan (ColorStream
connection
If your television is a high-definition or "digital ready"
television, you may take advantage of the DVD
Receiver's progressive scan output for the highest
video resolution possible.
If your TV does not accept the Progressive Scan
format, the picture will appear scrambled if you try
Progressive Scan on the DVD Receiver.
Connect the COMPONENT VIDEO OUT jacks on the
DVD Receiver to the corresponding in jacks on the TV
using a component video cables (C).
Notes
Set the Progressive Scan to "On" on the DVD setup
menu for progressive signal, see page 20.
Progressive scan does not work with the analog
video connections (yellow VIDEO OUT jack).
12
® )
(not supplied)
® pro)
Rear of TV
VIDEO
S-VIDEO
COMPONENT VIDEO INPUT
INPUT
INPUT
Y
L
V
S
VIDEO
S VIDEO
(DVD ONLY)
Y
MONITOR OUT COMPONENT VIDEO OUT
Rear of DVD Receiver
Pb Pr
C
(not supplied)
P C P C
B/ B R/ R