Deactivating Buttons On The Bar Speaker (Child Lock); Changing The Brightness; Saving Power In Standby Mode - Sony HT-RT5 Manuel D'instructions

Deactivating Buttons on
the Bar Speaker (Child
Lock)
You can deactivate buttons on the Bar
Speaker (except for ) for preventing
misoperation, such as child mischief.
Be sure to use buttons on the Bar Speaker
to perform this operation.
Press and hold INPUT followed by
VOLUME –, VOLUME +, VOLUME – on the
Bar Speaker.
"LOCK" appears in the front panel display.
You can only operate the system by using
the remote control.
To cancel, press and hold INPUT followed
by VOLUME –, VOLUME +, VOLUME – on
the Bar Speaker.
"UNLCK" appears in the front panel
display.

Changing the brightness

You can change the brightness of the
front panel display and blue LED
indicator.
Press DIMMER repeatedly.
You can adjust the brightness in 3 levels.*
* The brightness for "DIM1" and "DIM2"
settings are the same.
Note
• The front panel display is turned off when
"DIM2" is selected. It turns on automatically
when you press any buttons/touch keys,
then turns off again if you do not operate
the system for about 10 seconds. However,
in some cases, the front panel display may
not turn off.
Saving Power in Standby
Mode
Check that you have made the following
settings:
– [Bluetooth Standby] is set to [Off]
(page 27).
– [Standby Through] is set to [Off]
(page 28).
– [Quick Start/Network Standby] is set to
[Off] (page 29).
– [Remote Start] is set to [Off] (page 30).
37
US