FUXTEC FX-KSP351 Notice D'instruction D'origine page 48

Translation of original operating instructions for petrol chainsaw FX-KSP series
− minimise the risk of kickback
− minimise the risk of the retaining straps
tearing.
Guide rail wear
The guide rail must be checked at regular in-
tervals for wear of the guide groove.
The guide groove must be perpendicular for
operationally safe and smooth running of the
saw chain.
◼ Rotate the guide rail at regular intervals to
avoid one-sided wear.
1 Ruler
2 Gap
3 No gap
Chain runs properly in chain groove –
4
low risk!
5 Increased risk of accident!
Chain runs at an angle in chain groove
Checking the guide rail
◼ Place a ruler against the guide rail and the
outside of a saw tooth.
− If there is a gap between the guide rail
and the ruler, the guide groove is in
good order
− If there is no gap, the guide groove is
worn.
◼ If the guide groove is worn, turn the guide
rail around or renew it.
Further notes
CAUTION!
48
Clean the chainsaw after every operation. Neg-
ligence regarding the cleaning measures may
lead to material damage and malfunctions.
◼ Do not spray the chainsaw with water.
◼ Keep the vent slots clean and free of dust.
◼ Clean the saw chain and guide rail after
every use.
◼ For external cleaning, use a soft cloth and
a soft brush.
◼ Clean the tank cap seals regularly and re-
place if necessary.
Storage
◼ Store the equipment in a dry and frost-pro-
tected location (10°C – 25°C).
◼ Fit the transit cover on the saw chain.
◼ Keep all plastic parts away from brake
fluid, petrol, products containing mineral
oil, penetrating oil etc.
These contain substances that can dam-
age or destroy the plastic parts.
◼ Fertilizers and other garden chemicals
contain substances that have a strong cor-
rosive effect on metal parts. Therefore, do
not store the chainsaw near substances of
this kind.
◼ Only store the chainsaw with the fuel tank
and oil tank empty.
Transport
CAUTION!
Risk of injury!
If transporting and changing location during
work, always switch off the chainsaw!
For short distances:
WARNING!
Acute risk of accident!
Under no circumstances should the chainsaw
be transported while the chain is running!
◼ Fit the transit cover.
◼ Activate the chain brake.
◼ Carry the chainsaw by the front handle with
the guide rail pointing towards the rear.
For transport with a vehicle:
◼ Allow the chainsaw to cool down before
any transportation.