FUXTEC FX-KSP351 Notice D'instruction D'origine page 36

Translation of original operating instructions for petrol chainsaw FX-KSP series
Bumper spike assembly
◼ Screw the bumper spikes (14) firmly to the
equipment with two hexagon socket head
bolts (H).
Guide rail and saw chain assembly
DANGER!
Always switch off the engine and wait until it
has come completely to rest before tension-
ing or retensioning the saw chain!
◼ Pull front hand guard (chain brake) (3) in
the direction of the front handle (4) (1.).
− Check to ensure that the chain brake is
not activated.
◼ Unscrew 2 nuts (2.) on the chain guard
and remove the chain guard (3.).
◼ Place the saw chain (2) on the drive wheel.
36
◼ Through the elongated hole, push the guide
rail (1) onto the stud on the drive unit (A).
First fit the saw chain on the drive wheel (1.)
and then over the lower guide (2.). Then in
the front part of the guide rail fit in the
groove (3.) of the front gear ring (Q).
NOTE
When inserting the saw chain in the guide
rail, ensure that the saw chain is fitted cor-
rectly in the direction of saw rotation!
◼ To pretension the saw chain, pull the
guide rail forwards in the elongated hole.