FUXTEC FX-KSP351 Notice D'instruction D'origine page 27

Translation of original operating instructions for petrol chainsaw FX-KSP series
Contents
Symbols used in this manual .................. 27
Symbols on chainsaw .............................. 27
Important safety information .................... 28
Noise and vibration.................................. 32
Overview ................................................. 33
Technical specifications .......................... 34
Instructions for use .................................. 35
Work techniques ..................................... 42
Maintenance and care ............................. 44
Disposal information ................................ 49
conformity .......................................... 50
Symbols used in this
manual
WARNING!
Denotes impending danger. Non-observance
of this warning may result in death or ex-
tremely severe injuries.
CAUTION!
Denotes a potentially dangerous situation.
Non-observance of this warning may result in
injury or damage to property.
NOTE
Denotes tips for operation and important in-
formation.
Symbols on chainsaw
Opening for refilling "MIX GAS-
OLINE" 40:1
Location: Above fuel cap
Opening for refilling chain oil
Location: Above oil cap
Switch notices: Pressing the
switch to the "O" (STOP) posi-
tion switches off the engine.
Location: On left next to
ON/OFF switch handle
Pulling the choke button (see page 9, no. 16)
as far as the arrow allows the starting mode
to be adjusted as follows:
Position 1 when engine is cold.
Position 0 when engine is hot.
Location: On front of air filter cover
The directions indicate when
the chain brake is released
(white arrow) and activated
(black arrow).
Location: On front of chain cover
Cable starter with Easy Start
function. To start the machine,
preload the starter spring by
pulling slowly and evenly. It is
not necessary to yank it. Do
not pull beyond the dead cen-
tre point as the cable could oth-
erwise snap.
If the screw is turned with a
screwdriver in the direction of
arrow to the "MAX" position, oil
flow is stronger. Turning to the
"MIN" position results in oil flow
being weaker.
Location: On bottom of device
Warning notices sign
The chainsaw has a sign with WARNING
NOTICES.
27