Publicité
Les langues disponibles
Les langues disponibles
Translation of original operating instructions for petrol chainsaw FX-KSP series
◼ Do not use the equipment unless it is tech-
nically sound as prescribed and supplied
by the manufacturer.
◼ Unauthorised modifications to the equip-
ment will render the warranty void and the
manufacturer will accept no liability for any
resulting damage.
General safety instructions
WARNING!
Read all safety instructions and general
instructions. Failure to observe the safety
instructions and information can cause a fire
and/or severe injury.
Keep all warnings and instructions for fu-
ture reference.
◼ Never operate the chainsaw if fatigued or
excited or otherwise in a physically unfit
state.
◼ Do not under any circumstances work with
the chainsaw if medication with a calming
effect and/or drugs have been taken.
◼ Do not leave the engine running in en-
closed rooms or buildings. The emissions
contain dangerous carbon monoxide.
◼ Do not saw in inclement weather, if vision
is impaired or temperatures are extremely
high or low.
◼ Make sure on a trunk to be sawn that there
are no dry branches that could break off.
◼ Wear non-slip footwear, close-fitting work-
wear, protective goggles, ear defenders
and a safety helmet.
◼ Always wear certified safety gloves with
cut protection when working with the
chainsaw.
◼ With the exception of the measures listed
in these operating instructions, have all
maintenance work on the chainsaw car-
ried out by authorised and qualified
maintenance personnel.
◼ Exercise particularly caution when cutting
bushes and undergrowth as thin branches
could get caught in the chain, throw you
off balance and cause injuries.
◼ Be aware of potential kickback when cut-
ting a branch under load.
◼ Always perform cleaning and maintenance
measures before placing in storage.
◼ Make sure that the chainsaw is always
switched off before performing assembly,
adjustment and maintenance measures.
◼ Note that maintenance carried out incor-
rectly, the use of spare parts that do not
conform to the standard or the removal of
or modification to safety devices and
guards could cause damage to the equip-
ment and very serious injuries.
◼ Check at regular intervals that the saw
chain stops turning when the engine is
running at idle.
◼ Never allow the chainsaw to fall into the
hands of unauthorised persons and chil-
dren!
◼ Note that national regulations may restrict
the use of the machine.
◼ Check the chainsaw before use for signifi-
cant damage and defects.
◼ It is good practice before using the chain-
saw to receive induction training.
◼ Only use saw chains and safety devices
prescribed by the manufacturer. The use
of other tools and accessories increases
the risk of injury to the user.
◼ Always keep the chainsaw is good condi-
tion.
◼ The chainsaw is fitted with bumper spikes
(dog teeth). Always place the bumper
spikes against the trunk when cutting. The
bumper spikes serve as a means of oper-
ating the chainsaw safely and easily. It im-
proves the operator's stability when cut-
ting. It can be anchored in the wood and,
in this way, used as a pivot point.
◼ Always start sawing as evenly as possible
and close to the bumper spikes.
Kickback and relevant precaution-
ary measures
Attention! Chainsaw kickback can be caused
by the following:
◼ Contact of the guide rail tip with a solid ob-
ject.
◼ Wood being cut compressing and clamp-
ing the guide rail.
29
Publicité
