FUXTEC FX-KSP351 Notice D'instruction D'origine page 46

Translation of original operating instructions for petrol chainsaw FX-KSP series
◼ Clean the electrodes with a wire brush.
◼ Check the electrode gap (X) with a gauge.
Adjust to 0.6 ... 0.7 mm if necessary.
◼ Screw the spark plug with seal firmly into
the engine housing.
46
Mounting the spark plug
The components are assembled in the re-
verse order of removal (see diagrams above).
NOTE!
A spark plug wrench of the correct size is in-
cluded.
Cleaning cylinder cooling fins
WARNING!
Heavily contaminated cooling fins will cause
the engine to overheat and result in engine
damage!
◼ Loose screw to lift filter cover
◼ Remove the filter cover and filter.
◼ Pull off the spark plug connector.
◼ Unscrew 5 securing bolts:
− 2 countersunk securing bolts next to
the quick-fit clips
− 2 securing bolts that are accessible af-
ter removing the filter cover; the air filter
must be removed
− 1 countersunk securing bolt on the side
in the area of the chain brake lever.
◼ Lift off the cylinder housing.
◼ Clean the cylinder cooling fins by suitable
means, e.g. a wire brush.
◼ Mount the cylinder housing again.
NOTE!
Ensure, when installing the cylinder housing,
that all switch wires and attachments are lo-
cated back in their original position.
Saw chain
NOTE!
Acquire the necessary information about ac-
cessories (gauges, associated files etc.) and
instructions about resharpening your saw
chain from the manufacturer or a specialist
dealer.
For reliable and trouble-free operation, the
teeth of the saw chain must always be sharp.