HOLZMANN MASCHINEN BBS810SMART-G Mode D'emploi page 56

TROUBLESHOOTING
If you are unable to carry out the necessary repairs properly and/or do not have the required
training, always consult a specialist to solve the problem.
Problem
Producing wavy cuts
Last board is tapered or
narrow in the middle.
Blade comes off of band
wheels
Blades are breaking.
Blade is slowing down or
stopping when milling
Mill is not cutting/cutting
very
slowly.
Mill is vibrating excessively.
Engine doesn't start
Engine stops after a short
time
HOLZMANN Maschinen GmbH
Possible cause
1. Inadequate blade tension.
2. Improper blade guide set up.
3. Improper blade tracking.
4. Sap build up on blade.
5. Dull blade.
6. Pushing mill too quickly.
Tracks are not levelled.
1. Inadequate blade tension.
2. Improper blade guide set up.
3. Improper blade tracking.
4. Belts are worn.
5. Dull blade.
6. Pushing mill too quickly.
1. Too many blade sharpening's.
2. Inadequate blade tension.
3. Improper blade guide set up.
4. Improper blade tracking.
5. Pushing mill too quickly.
1. Inadequate blade tension.
2. Improper drive belt tension.
3. Pushing mill too quickly.
1. Dull blade.
2. Blade-teeth are backwards.
1. Log is not clamped securely.
2. Belts are deformed.
3. Bandwheel bearing issue.
4. Pushing mill too quickly.
5. Loose bolts.
1. too less engine oil quantity
2. no/too less fuel
3. emergency stop switch pressed
(not on start)
4. open safety-guard (blade cover-
microsswitch)
1. choke in position "closed
2. fuel tap closed
www.holzmann-maschinen.at
TROUBLESHOOTING
Remediation
1. Tighten blade
2. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new blade and ensure to run
always with blade lubrication.
5. Install new blade.
6. Slow feed rate down and push head
slower through log.
Level the tracks
1. Tighten blade
2. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new belts.
5. Install new blade.
6. Slow feed rate down and push head
slower through log.
1. Install new blade
2. Adjust blade tension
3. Adjust blade guidance.
3. Adjust blade tracking.
4. Install new belts.
5. Slow feed rate down and push head
slower through log.
1. Tighten blade
2. Adjust V-Belt tension
3. Slow feed rate down and push head
slower through log
1. Install new blade
2. Assemble blade correct
1. Ensure log is clamped firmly resting on
log bunks and against log supports.
2. Install new Belts
3. Install new band wheel bearings
4. Slow feed rate down when milling.
5. Check all bolts to ensure they are tight.
1. check/refill engine oil
2. check/refill fuel
3. unlocking emergency stop switch
4. Close and tighten safety-guard
1. choke in position "open
2. open fuel tap
56
BB810SMART-G