HOLZMANN MASCHINEN BBS810SMART-G Mode D'emploi page 52

Adjusting belt tension
Adjusting blade tracking
Right side
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Loosen the 4 nuts on the motor.
Now that the motor can slide freely on the
motor bracket, turn the 16mm nut (A) on the
horizontal bolt clockwise. This will pull the
motor towards the pin and tighten the belt
more. Perform this step, step by step while
checking the belt for correct deflection. It is
also important to ensure that the motor is
perpendicular to the drive belt. Excessive
tightening may cause the motor to twist on
the mounting plate, causing belt alignment
problems and excesive wear. Once the desired
belt tension is set, tighten the four motor
bolts, if the drive belt is too tight, the 16mm
nut on the horizontal bolt can be turned
counterclockwise.
The blade should have the same distance
between teeth to band wheel on both sides. If
not, the following settings must be achieved.
1. Remove blade guide to ensure no influence on
tracking while adjusting.
2. Take some tension off of the blade.
3. Adjusting the Right side:
Loosen the screw. With the adjustment screw,
the angle of the wheel can now be changed. To
move the blade on the wheel backwards, this
screw must be rotated clockwise. Alternatively,
turning the anti-clockwise bolt would force the
blade to run more forwards on the wheel.
4. Adjusting the Left Side
Loosen the vertical screws by half a turn, this will
take the clamping force off of the bandwheel
shaft and allow it to move freely in the following
steps.
Moving the blade forward:
Fix the horizontal screw (with a tool) and loosen
the outer horizontal nut by a 1/2 turn. Then rotate
the horizontal screw clockwise around a 1/2 turn.
Moving the blade backwards:
Fix the horizontal screw (with a tool) and loosen
the outer horizontal nut by a 1/2 turn. Then turn
52
BB810SMART-G