Publicité
Les langues disponibles
Les langues disponibles
15.1
Information on initial start-up
Please note that the machine is delivered without motor oil and fuel. Make sure that
these operating fluids are filled before initial operation.
WARNING: The machine will not start until the motor oil has been filled up to the
maximum limit.
Test run initial start-up
Let the machine run at idle for approx. 3 minutes.
•
Pay attention to abnormal noises.
•
•
Pay attention to the exhaust fumes (too black, too white)?
Notes for the first 20 operating hours
In order to optimise the life expectancy of your machine, you should follow these points:
•
Take care of the engine for the first 20 hours of operation (this also applies to used engines
after comprehensive maintenance). This means lower speed and lower maximum workload
than during normal operation.
•
Change the motor oil after the first 20 hours of operation.
15.2
Operation
Start the engine
Start the engine when you have assembled your mini dumper according to instructions and it is
filled with the necessary fuel and oil:
HOLZMANN Maschinen GmbH
HINWEIS
1.
Set the gear selection lever to the neutral position.
2.
Machine clutch lever released.
3.
Move the choke lever to the CLOSED position.
If the motor is hot, closing the choke is not necessary.
4.
Turn ON-OFF-Switch to "ON" position / unlock emergency
swith on the handle.
5.
Open the fuel shut-off valve.
6.
Pull the recoil starter handle several times so that the
carburettor is filled with gasoline.
Pull-out the starter handle until resistance is felt. Let the
rope rewind slowly across and then move expeditiously.
Run the recoil starter handle slowly to the rope guide back
as soon as the engine starts.
7.
Set the choke lever after a few seconds of engine run
position ˝OPEN˝.
www.holzmann-maschinen.at
OPERATION
49
BB810SMART-G
Publicité
