VM Motori R754ISE5 Manuel D'instructions Pour L'emploi page 117

TROUBLESHOOTING
If an error code is displayed on the vehicle display or signalled by an acoustic alarm,
promptly contact the manufacturer of the vehicle in which the engine is installed or a
workshop authorised by VM MOTORI STELLANTIS EUROPE.
Do not use the engine until the problem has been solved and the error has been cleared
using specific diagnostic equipment available at the authorised centres.
The information below (see tables on pages 57 and 58) is provided to facilitate the
identification and solution of any anomalies and malfunctions that may occur during
engine operation.
IMPORTANT
The engine is provided with an
electronic control unit that records
the engine faults and generates a
diagnosis code stored in the control
unit memory. The "fault code" is
displayed in the instrument panel of the
vehicle in which the engine is installed
and may be further signalled by the
enabled MIL warning light described
on page 28 and DWS warning light on
page 31.
Problem
During the ignition phase the
instrument panel and the engine
do not start
The engine does not start
The starter motor runs idle
The starter motor is not running
The engine stops after ignition
Whitish oil in the sump
Abnormal smoke emission from
the engine exhaust
English
INFORMATION ABOUT FAILURES
Cause
To be investigated with suitable
diagnostic equipment
To be investigated with suitable
diagnostic equipment
Electromagnet failure
To be investigated with suitable
diagnostic equipment
To be investigated with suitable
diagnostic equipment
Oil contaminated by other liquid Contact an authorised workshop
To be investigated with suitable
diagnostic equipment
57
CAUTION - WARNING
Do not attempt to carry out diagnosis
and maintenance operations that you
are not capable of doing.
Contact an authorised work-
Contact an authorised work-
Contact an authorised workshop
Contact an authorised workshop
Contact an authorised workshop
Contact an authorised workshop
R754ISE5
Remedy
shop
shop
42432106F
GB