VM Motori R754ISE5 Manuel D'instructions Pour L'emploi page 107

4 - Fit a new seal (R), screw the drain plug
(Q) back on and tighten to a torque of 54
Nm.
5 - Pour the new engine oil until it reaches
the correct level on the oil dipstick (see
Engine Oil Level Check on page 45 and,
for oil quantities, see General Data on
page 14.
6 - Screw in the plug (M).
7 -Start the engine and bring it to the
operating temperature of 70°C - 80°C
(158°F - 176°F) for approx. five minutes.
Make sure there are no oil leaks.
8 - Turn off the engine and check the oil
level (see Engine Oil Level Check on page
45).
English
IMPORTANT
If necessary, contact the manufacturer
of the vehicle in which the engine is
installed or a workshop authorised by
VM MOTORI STELLANTIS EUROPE.
IMPORTANT
Do not dump any polluting material
in the environment. Carry out their
disposal in compliance with the
legislation in force.
47
R754ISE5
GB
42432106F