VM Motori R754ISE5 Manuel D'instructions Pour L'emploi page 104

AIR FILTER CLEANING AND REPLACEMENT
1 - Turn off the engine and remove the
ignition key.
GB
The air filter is equipped with a clogging
indicator (A) that gradually switches from
white (clean filter) to red (clogged filter).
When the indicator is red, proceed as
follows:
2 - Unscrew the fastening screw (B),
disassemble the cyclone pre-filter (C) and
clean it with compressed air lower than 5
bar.
3 - Open the closing hooks (D) and
disassemble the cover (E).
4 - Remove the "main" filter cartridge (F),
and clean it with a compressed air jet lower
than 5 bar aimed outwards.
5 - Check the wear condition of the "main"
filter cartridge (F) and, if necessary,
replace it, or contact the manufacturer of
the vehicle in which the engine is installed
or a workshop authorised by VM MOTORI
STELLANTIS EUROPE.
6 - Clean the air filter body (H) with a
clean, lint-free cloth dampened with non-
aggressive biodegradable detergent.
7 - Replace the filter safety cartridge
(G) if damaged. In any case, replace
the cartridge (G) after 5 (five) cleaning
operations on the main filter cartridge (F),
or contact the manufacturer of the vehicle in
which the engine is installed or a workshop
authorised by VM MOTORI STELLANTIS
EUROPE.
8 - Refit the main cartridge (F), the cover
(E) and the cyclone pre-filter (C).
9 - At the end of the operation, press
the button of the clogging indicator (A)
towards the filter body to reset its colour.
English
E
G
H
D
A
CAUTION - WARNING
Wear protective goggles and dust mask.
Never aim the compressed air jet at
people or at yourself. Do not allow solid
or liquid substances to enter the engine
intake ducts.
IMPORTANT
If necessary, contact the manufacturer
of the vehicle in which the engine is
installed or a workshop authorised by
VM MOTORI STELLANTIS EUROPE.
44
R754ISE5
F
B
C
42432106F