VM Motori R754ISE5 Manuel D'instructions Pour L'emploi page 112

AIR BLEEDING FROM FUEL SUPPLY CIRCUIT
IMPORTANT
GB
This operation must be carried out after
each fuel filter cartridge replacement.
Follow the procedure below:
IMPORTANT
Turn off the engine and remove the
ignition key. Wait at least 6 minutes
before disconnecting the negative
battery cable.
1 - Carry out the operation with the engine
cold.
2 - Avoid contact with hot engine parts
and fuel. Wear appropriate gloves and
clothing.
3 - Prepare a container with appropriate
capacity under the fuel filter.
4 - Partially loosen the screw (E) to allow
the fuel to be bled to drain.
5 - Manually activate the pump (F) until
the fuel drained has no air bubbles.
6 - Tighten the screw (E).
IMPORTANT
Thoroughly dry the fuel residues before
starting the engine.
English
E
CAUTION - WARNING
Do not use the starter motor to try to
bleed air from fuel circuit.
CAUTION - WARNING
Do not loosen high-pressure pipe
unions of fuel supply circuit.
52
R754ISE5
F
42432106F