VM Motori R754ISE5 Manuel D'instructions Pour L'emploi page 113

WATER BLEEDING FROM FUEL SUPPLY CIRCUIT
If the alarm light "water in the fuel"
lights up, (on vehicles provided with this
function), proceed as follows.
IMPORTANT
Turn off the engine and remove the
ignition key. Wait at least 6 minutes
before disconnecting the negative
battery cable.
1 - Carry out the operation with the engine
cold.
2 - Avoid contact with hot engine parts and
bled fuel. Wear appropriate gloves and
clothing.
3 - Prepare a container with suitable
capacity under the fuel filter (A) fig. to the
side.
4 - Unscrew the water presence sensor
(B) fig. to the side. Allow fuel mixed with
water to drain into the container until only
compliant fuel is drained.
5 - Screw the sensor (B) back fig. to the
side.
IMPORTANT
Thoroughly dry the fuel residues before
starting the engine.
IMPORTANT
Dispose of non-compliant fuel in
accordance with the regulations in
force.
English
A
B
CAUTION - WARNING
The water must be bled immediately
after use of the engine in case of
freezing ambient temperature.
CAUTION - WARNING
Do not use the starter motor to try to
bleed air from fuel circuit.
CAUTION - WARNING
Do not loosen high-pressure pipe
unions of fuel supply circuit.
53
R754ISE5
GB
42432106F