Burkert 8026 Démarrage Rapide page 18

Type 8026 - 8036 - 8076
Installation and wiring
Correct
Fig. 8.5 The oval gear axes must be horizontal (seen from the front)
→
Fit the display module to be able to programme the transmitter
Refer to the instruction manual of the display module (order
code 560331, delivered with the display module) for the
mounting and dismounting instructions.
→
Install electronic module SE36 on fitting S070 (transmitter
8076) (see figure 8.6 below)
→
→
Fig. 8.6 Assembly of the SE36 on an S070 fitting
All manuals and user guides at all-guides.com
In cor rect
1: Inserting the electronic module into
the fitting holder.
2: Turn the electronic module by a
quarter turn.
→
Programme the K factor (see § 10.5) or determine it using
Teach-in
8.3. Electrical wiring
DANGER
Risk of injury due to electrical discharge.
• Shut down and isolate the electrical power source before carrying
out work on the system.
• Observe all applicable accident protection and safety regulations
for electrical equipment.
• Use a high quality electrical power supply (filtered
and regulated).
• Guarantee the equipotentiality of the installation.
• Use shielded cable.
8.3.1. Electrical wiring
Number of fixed connec-
tors:
1 M12 male fixed connector M12 female, 5 pins (not delivered)
1 M12 male fixed connector
+ 1 M12 female fixed con-
nector
english
Type of cable plug
M12 female, 5 pins + M12 male, 5
pins (not delivered)
15