Burkert 8026 Démarrage Rapide page 17

→
Fit the display module to be able to programme the transmitter
Refer to the instruction manual of the display module (order
code 560331, delivered with the display module) for the
mounting and dismounting instructions.
→
Assemble electronic module SE36 and S030 fitting (transmit-
ter 8036) (see figure 8.3 below) or install transmitter 8026 into
S020 fitting (see figure 8.4 opposite)
→
→
→
Fig. 8.3 Assembly of the SE36 on an S030 fitting
14
All manuals and user guides at all-guides.com
1: Inserting the electronic module into
the fitting holder.
2: Turn the electronic module by a
quarter turn.
3: Secure the electronic module and
the S030 fitting, by tightening the
screw with a suitable tool to a max.
tightening torque of 1 Nm.
english
Type 8026 - 8036 - 8076
Installation and wiring
→
→
→
→
Fig. 8.4 Install transmitter 8026 into S020 fitting
→
Programme the K factor (see § 10.5) or determine it using
Teach-in
8.2.2. Recommendations on installing an
8076 on a pipe
→
Install the S070 fitting on the pipe in such a way that the oval gear
axes are in the horizontal plane, as shown in Fig. 8.5.
Check that there is a seal on the
fitting and that it is not damaged.
Replace the seal if necessary.
Place nut A on the fitting and insert
circlip B into the groove.
Carefully insert the transmitter into
the fitting. If assembly is correct, the
transmitter can no longer rotate on
itself.
Secure the unit with nut A, tighten-
ing only by hand.