Dräger X-node Notice D'utilisation page 14

en |
Intended use
5 Intended use
The measurement system constantly measures the concentration of
the harmful gas, depending on the sensor used, in the ambient air
under atmospheric conditions.
6 Usage
6.1 Prerequisites for use
CAUTION
Risk of malfunction
The function of the sensing head is tested prior to delivery, but a
functional test must still be carried out after installation (see chapter
"Testing the sensitivity").
► A functional test must be carried out by the user.
6.2 Installing the sensor
1. Twist off the bayonet ring (5).
2. Remove the sensor from its packaging.
3. Place the sensor (4) in the opening.
4. Secure the sensor with the bayonet ring.
7 Dräger X-node app
To configure the sensing head, install the Dräger X-node app on a
Bluetooth-enabled iOS or Android device.
The Dräger X-node app is used for data exchange with Dräger X-
node gas sensing heads via Bluetooth. The initial connection to the
device via Bluetooth can only be established with the help of an
Owner Key for reasons of safety. The Owner Key is enclosed in the
package. Additional information can be found in the device's technical
manual.
14
KSPD-0177
X-node 1
Owner Key: 2M5AF9V23H6R
Part Number: 5601008
Serial Number: KSPD-0177
LW:D0:0000000000000055:FC824A9A324C0E54:04BC0001:O2M5AF9V23H6R:SKSPD0177:P722A53C10E545601008:C4B90
Select the sensing head from the menu. The following functions are
supported, among others:
– Defining the PIN
– LoRa provisioning
– Querying user authorization
– Displaying device data
– Displaying measured values
– Configuring the sensing head
– Calibrating the sensor
– Defining the alarm thresholds
– Carrying out firmware updates
– Logger of the last 7 days
Further operating instructions are provided in the Dräger X-node app.
Instructions for use |
Dräger X-node