hestan KSO 30 Manuel D'utilisation page 36

OVEN CARE AND CLEANING
TO SET THE SELF-CLEAN MODE
1. Touch [UPPER/LOWER] key to select the cavity to be cleaned, if the oven is a double.
EN
2. Rotate both knobs into the clean position.
3. CLEAN & TIME appear. This is the clean time, its standard value is 3 hours.
4. If desired, adjust the cleaning time per instructions below.
5. When the cleaning time is accepted, the door will begin to lock.
• The "AUTO LOCK" message will flash until the door is locked.
6. When AUTO LOCK stops flashing, check that the door has been locked and will not open.
7. If door does not lock, rotate the cooking mode knob into the OFF position and do not start
self-clean; contact Hestan Customer Care for service.
• Provide good ventilation to the room during and immediately after self-cleaning the oven.
• To stop the cleaning mode at any moment, move either of the two knobs from the cleaning
position.
• At the end of the programmed cleaning time, the oven will automatically turn off.
TO CHANGE THE CLEANING TIME
1. To change the setting from 3 hours, select either 2 hours for light soil or 4 hours for heavy
soil immediately before starting.
2. To change the hours, touch the
3. The hours will flash.
4. Use
+
5. To change the minutes, touch the
6. The minutes will flash.
7. Use
+
8. Touch
TO DELAY THE START OF CLEANING
1. Follow steps 1 through 7 above.
2. Touch the
begin flashing.
3. Use
+
4. To change the minutes, touch the
5. Use
+
6. Touch
The latch starts moving to lock the oven door, the display shows "DELAY"..
When the delay time expires, self-cleaning will start.
At the end of the programmed cleaning time, the oven will automatically turn off.
"End" will appear on the temperature display, "CLEAN" on the mode display and "TIME" on the
clock display will start flashing until the
position.
• In order to check the cleaning or the stop time during a delayed clean, simply touch the
key until "TIME" or "STOP TIME" message is displayed.
TIME
34
©2018 Hestan Commercial Corporation
All manuals and user guides at all-guides.com
TIME
or keys to change the value.
-
or keys to change the value. Hold the key to change by 10 minutes steps.
-
or wait a few seconds to confirm the new value.
TIME
key and verify that "STOP TIME" appears on the display. The hours will
TIME
or keys to change the stop time value.
-
or keys to change the value. Hold the key to change by 10 minutes steps.
-
or wait a few seconds to confirm the new value.
TIME
(CONT.)
key.
key again.
TIME
key, the minutes will flash.
TIME
key is touched or the knob is moved to the OFF
TIME