Publicité
Replace the Battery
B
A
+
Replace battery with Panasonic PART NO. VSBW0004 (CR2025) only. Use of another battery may
present a risk of fire or explosion.
Caution: Battery may explode if mistreated. Dispose of used battery properly. Keep away from
children. Do not recharge, disassemble or dispose of in a fire.
Remote Controlling Two
Palmcorders
You can control any two Panasonic
Palmcorders with one Remote control. In
order for the remote to distinguish between
the two units, it is necessary to set one of
the Palmcorders to VCR 2. On the remote,
press VCR 1 or VCR 2 to control the
desired Palmcorder.
For VCR 2 :
Press these
buttons at the
same time.
Note
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
DV102-K.p 5-9.p65
1
While pressing the tab in the direction of the arrow (A)
with your fingernail, pull out the Battery Tray (B).
2
Insert the battery into the Battery Tray with the
facing up.
Do not reverse the polarity.
3
Insert the Battery Tray.
1
Set POWER to VCR or CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
2
Press MENU to display the VCR or
CAMERA mode menu screen.
3
Rotate JOG KEY to select
the CAMERA mode menu screen or
PLAY MODE
screen, then press JOG KEY to
display the CAMERA SET-UP or VCR
PLAY MODE menu screen.
For VCR 1 :
4
Press these
Rotate JOG KEY to select
buttons at the
and then press JOG KEY to select
same time.
VCR 2. (Menu OSD: pp. 57, 58).
Leave the other Palmcorder set to
VCR1.
5
Set the Remote Control to VCR 1 or
VCR 2 to correspond with the
Palmcorder you wish to control. (See
above left.)
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
9
Before Using
+
mark
SET-UP
in the VCR mode menu
REMOTE
02/06/06, 13:12
in
,
9
Publicité
