Publicité
Copying your Tapes to
VHS Cassette
Source (Playing)
Palmcorder
A/V Cable
(Supplied)
Recording:
VCR (Rear)
To Audio In
To Video In
Monitor with your TV
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
DV102-K.p41-44.p65
Editing Features
Before you begin
• Connect both Palmcorder and VCR to
their power sources.
• Connect the Palmcorder to a VCR as
illustrated left.
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER to VCR.
A/V OUT
1
Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
2
TV
Press
(To View)
When the tape reaches the point from
which you want to start dubbing, press
PAUSE.
3
VHF Connecting
Cable (not
Place the VCR into REC/PAUSE
supplied)
mode. (See VCR manual.)
4
Simultaneously, press PAUSE on
both units to begin copying.
5
Audio In
Video In
Press STOP on both units when
copying is completed.
Note
• For technical reasons, dubbing a tape
may reduce its quality.
• Press DISPLAY ON TV on the
Palmcorder Remote Control to eliminate
EVF/LCD Monitor indications.
• If the Time Code is displayed in the EVF
or LCD monitor, it cannot be reset.
• Only the DATE/TIME, when displayed,
will be recorded on the tape.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
43
(PLAY) on the Palmcorder.
43
02/06/06, 13:14
Publicité
