Publicité
Editing Features
Copying from Digital
Equipment (dubbing)
High quality digital-to-digital copying can
be accomplished if both Palmcorders
incorporate the DV Input/Output (i.LINK)
Connector (DV Interface cable (i.LINK) is
not supplied).
Source (Playing)
Palmcorder
DV Interface
Cable (i.LINK)
(optional)
(PV-DDC9-K)
3, 4, 5
3, 4
PAUSE
4
REC
3, 4, 5
PAUSE
6
STOP
44
DV102-K.p41-44.p65
Before you begin
• Connect both Palmcorders to their
power sources.
• Connect the two Palmcorders using the
DV Interface cable (i.LINK)
(4-pin to 4-pin).
• Turn both Palmcorders ON.
1
Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
2
Insert a blank tape with the record
DV Input/Output
tab closed into the target (recording)
(i.LINK) Connector
Palmcorder and set POWER to VCR.
3
Recording
Press
Palmcorder
Palmcorder. When the tape reaches
the point from which you want to start
dubbing, press
4
Hold down REC and press
on the target (recording) Palmcorder.
Press
the starting point of the dub.
5
Simultaneously, press
PLAY
both units to begin dubbing.
6
Press
unit, and then press
playing unit to end dubbing.
6
Note
STOP
• When two Palmcorders are used for
dubbing, it is recommended that the
Remote Control VCR1 or VCR2 setting be
used to avoid improper-operation.
4
REC
3, 4
CAUTION:
PLAY
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
44
(PLAY) on the source
(PAUSE).
(PLAY)
(PAUSE) to pause the tape at
(PAUSE) on
(STOP) on the recording
(STOP) on the
02/06/06, 13:14
Publicité
