Publicité
Supplying Power
Charge the Battery Pack on
the AC Adaptor
POWER Lamp
CHARGE Lamp
Note
About the Flashing of the CHARGE Lamp
• Charge the Battery within an ambient temperature range of 10 °C (50 °F) and
30 °C (86 °F).
• If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
• The Battery is being charged, but charging is taking longer than normal.
• Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
Insert the Battery Pack
2
1
Insert the Battery Pack and slide it up
until it locks with a click.
12
DV102-K.p10-12.p65
1
Connect and plug in the Power Cord
as shown.
• POWER Lamp will light.
• Remove the DC Cable, if attached,
from the adaptor.
2
Attach the Battery as shown to
charge.
• CHARGE Lamp lights up. It goes out
when charging is complete (approx.
1 hour). Expect approx. 1 hour
30 minutes of operation (EVF usage)
when fully charged.
3
Remove the Battery.
Slide the Battery out and then lift up.
Remove the Battery Pack
1
1
Tilt Viewfinder upward.
2
Remove the Battery Pack and slide
the Battery downward while sliding the
BATT RELEASE.
12
1
3
2
BATT RELEASE
02/06/06, 13:12
Publicité
