Publicité
Audio Dubbing using the
Built-in Microphone
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone.
Built-in Microphone
3
JOG KEY
3
MENU
1
POWER
2
2
PAUSE
3
A.DUB
DV102-K.p41-44.p65
Editing Features
Before you begin
• Turn on the Palmcorder.
• Insert a pre-recorded tape to be
dubbed.
The AUDIO-REC setting in CAMERA
MENU mode should be as follows:
12 bit
16 bit
• Select 12 bit if you do not want the
original sound to be completely replaced
during an audio dub.
• If you dub over a tape which has both
12 bit and 16 bit audio recordings on it,
keep in mind that the original 16 bit audio
portion will be completely replaced.
1
Set POWER to VCR.
• With the Remote Control, you can set
the Palmcorder to stop automatically
at a specific point on the tape. See
"Memory-Stop Editing" on page 42.
2
Press
(PAUSE) where you want dubbing to
PLAY
begin.
When using the Palmcorder only
3
Press MENU to display the VCR mode
menu screen.
Rotate JOG KEY to select
then press JOG KEY to display the
VCR REC MODE menu screen.
Rotate JOG KEY to select
DUB
select ON.
• The Palmcorder will go to Stand By
mode, and "A.DUB " indication
appears in the EVF or the LCD
monitor. Go to step 4.
When using the Remote Control only
3
Press A.DUB on the Remote Control.
• The Palmcorder will go to Stand By
mode, and "A.DUB " indication
appears in the EVF or the LCD
monitor. Go to step 4.
41
The original sound is recorded
on ST (Stereo) 1, and the new
sound will be recorded on ST
(Stereo) 2.
The original sound is replaced
with the new sound.
(PLAY). Then press
REC MODE
AUDIO-
, and then press JOG KEY to
(Continued on next page.)
02/06/06, 13:14
,
41
Publicité
