Publicité
On-Screen Displays (OSD)
The following warning displays appear in the EVF and the LCD monitor.
Indications
Condition
If the Palmcorder is in CAMERA mode without a cassette inserted,
"
5 seconds. Recording will not start.
If the Palmcorder is in CAMERA mode or Audio dub mode with
the cassette sliding record tab opened, "
"CHECK REC TAB" will appear for 5 seconds. Recording will not
start.
When Audio dub is performed and recording is other than NTSC
format, "
seconds.
When the tape is about to end in REC mode, "
flash and "TAPE END" will appear for 5 seconds.
When an incompatible tape is detected, "INCOMPATIBLE
TAPE" will appear for 5 seconds.
If the video heads require cleaning, "NEED HEAD CLEANING"
will appear for 5 seconds.
When the Palmcorder and remote are not set to the same mode
(VCR1 or VCR2), "CHECK REMOTE MODE (REMOTE)" appears
for 5 seconds. It also appears when the Palmcorder is first turned
on.
When an AUDIO DUB is attempted on a pre-recorded LP tape,
"CANNOT REC LP-MODE" will appear for 5 seconds.
If excessive moisture condenses in the unit, "WARNING" will
flash, "DEW DETECTED" will appear, and the Palmcorder will
automatically turn OFF in 15 seconds.
In this case, wait until the indicator no longer flashes when your
Palmcorder is turned ON again.
When a battery recharge is necessary, "WARNING" will
flash, "LOW BATTERY" will appear, and the Palmcorder will
automatically turn OFF in 15 seconds. (p. 60)
When the built-in lithium clock battery is discharged, "CLOCK
BATTERY" will appear. To re-charge the lithium clock battery,
connect the AC Adaptor to the Palmcorder. Recharging takes
approx. 4 hours. Reset the clock after charging.
If you play a tape recorded in a format other than NTSC or you try
to copy copy-protected data, "INCOMPATIBLE DATA" will appear.
54
DV102-K.p51-54.p65
" will flash and "TAPE NOT INSERTED" will appear for
" will flash and "CANNOT REC" will appear for 5
54
" will flash and
END" will
02/06/06, 13:15
Publicité
