Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.4 Switching the e-bike system off
If no power output from the e-bike drive unit is
requested (e. g. because the e-bike is parked) and
no button on the control unit is pressed for approx.
10 minutes, the e-bike system and the battery pack
will automatically switch off to save energy.
Switching off the e-bike system via the on-board
computer
1. Press the on/off button
and hold for at least 1 second.
5.5 Charging the battery
DANGER
Improper charging of the battery can lead to serious injuries!
Improper charging may cause the battery or other inflammable materials nearby to catch fire.
• Also observe the safety instructions in chapter "2.2 Safe use of the battery pack".
• Only use the original charger.
• The charger or battery must not be kept near inflammable materials while charging.
• Only charge the battery when dry.
• Do not leave the battery unattended while charging it.
The battery pack can be charged at any time when removed or installed without shortening its service life. Interrupting the
charging process does not damage the battery pack.
The battery pack comes with a temperature control that only allows you to charge the battery within a temperature range
of 0 °C to +40 °C. If the battery pack is outside the charging temperature range, three LEDs of the battery charge indicator
will start to flash. Disconnect the battery from the charger until the temperature has adjusted. Only connect the
battery pack to the charger when the permissible charging temperature has been reached.
5.6 Battery charge indicator
Battery charge indicator on the on-board computer
The symbol "
" on the display of the on-board computer indicates the
battery charge.
Battery charge indicator on the battery
If the battery is removed from the e-bike, you can also read the battery
capacity from the battery charge indicator LEDs "
pack itself.
54
on the on-board computer
" on the battery
W
W
PURION
W
W
PURION
Publicité
Table des Matières
