Riding The Bike; Switching On The E-Bike System; Setting The Assistance Level; Switching The Walk Assist Function On/Off - Rose ROOT MILLER + Manuel D'instructions

5.

Riding the bike

5.1 Switching on the e-bike system

The e-bike system can only be activated when the following requirements are met:
• A sufficiently charged e-bike battery is inserted.
• The Kiox on-board computer is inserted.
Switching the e-bike system on via the on-board computer
Press the on/off button "
computer.

5.2 Setting the assistance level

You can set the level of e-bike pedal assistance by using the
buttons "+" or "–" on the control unit. You may change the
assistance level at any time, even while riding.
To increase the assistance level, press the "+" button on the
control unit until the desired assistance level is shown on the
on-board computer display. To reduce the assistance level,
press the "–" button.
You can choose between the following assistance levels:
• "OFF": The motor assistance is switched off, the e-bike can
be pedalled as a regular bicycle. While using this assistance
level, you cannot switch on the walk assistance function.
• "ECO": Effective assistance at maximum efficiency for maximum range.
• "TOUR": Constant assistance, for long tours.
• "SPORT": Powerful assistance for sporty off-road riding in undulating terrain, as well as for urban traffic.
• "TURBO": Maximum assistance for high cadence, for sporty riding.

5.3 Switching the walk assist function on/off

The walk assistance can help you push your e-bike. The
assistance provided depends on the selected gear and may
reach up to 6 km/h. The lower the selected gear, the lower the
speed in the walk assistance mode (at full power).
Only use the walk assistance function when pushing the e-bike.
There is a risk of injury, if the wheels of the e-bike are not in
contact with the ground while using the walk assistance.
Briefly push the "WALK" button on the control unit to activate
the walk assistance. Push the "+" button within 3 secs after
activation and hold it down.
→ The e-bike drive is activated.
Note: You cannot activate the walk assistance function when
assistance is switched „OFF".
The walk assistance will switch off, if:
• you release the "+" button,
• the wheels of the e-bike are locked (e.g. through braking or knocking against an obstacle),
• the speed exceeds 6 km/h.
" on the on-board
+
+
PURION
W W
PURION
W W
PURION
WALK
W W
53