REMOVING THE FREEZER DRAWER
The freezer drawer can be removed, if needed,
to fit through tight areas.
Read these instructions completely and carefully.
1
REMOVE THE BASKET
A
Open the freezer drawer until it stops.
B
The freezer basket rests on a frame inside
the freezer drawer. Lift the basket up at
the back.
C
Lift the front up and lift the entire basket
up and out of the drawer.
REMOVE THE DRAWER FRONT
2
FROM THE SLIDES
A
Remove the Phillips head screw on each
side of the railing.
DO NOT remove the hex head
screws from the rail assemblies.
Installation Instructions
A
DO NOT remove
hex head screws
Phillips Screw
DO NOT remove
hex head screws
(on some models)
REMOVE THE DRAWER FRONT
2
FROM THE SLIDES
B
Lift up on both sides of the freezer drawer
handle to separate the drawer railings
from the rail assemblies.
C
Set the drawer front on a non-
scratching surface.
D
Push the rail assemblies back into
locking position.
Rail
Drawer
Assembly
Assembly
REMOVE THE BASE GRILLE
3
(if needed)
If, after removing the freezer drawer and
refrigerator door, the refrigerator will still
not fit through a doorway, the base grille
can be removed.
A
Remove the base grille by grasping it at
the bottom and pulling it straight out.
22
(cont.)