Reversing The Door Swing; The Doors; Tools You Will Need; (Single Door Refrigerator Models Only) - GE 20 Série Manuel D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REVERSING THE DOOR SWING

IMPORTANT NOTES
When reversing the door swing:
NOTE: Door swing is not reversible on some
stainless steel models.
• Read the instructions all the way through
before starting.
• Handle parts carefully to avoid scratching
paint.
• Set screws down by their related parts to
avoid using them in the wrong places.
• Provide a non-scratching work surface for

the doors.

IMPORTANT: Once you begin, do not move
the cabinet until door-swing reversal is
completed.
These instructions are for changing the
hinges from the right side to the left side—if
you ever want to change the hinges back to
the right side, follow these same instructions
and reverse all references to left and right.
• Once door swing is finalized, ensure
the logo badge is properly aligned and
permanently secured to the door by
removing the adhesive cover on the back
side. NOTE: If necessary call Customer
Service for a replacement badge.
Unplug the refrigerator from its electrical
outlet.
Empty all door shelves, including the dairy
compartment.

TOOLS YOU WILL NEED

Adjustable Wrench
Masking Tape
Phillips Screwdriver
Installation Instructions
3/8" and 10 mm Socket
Ratchet/Driver
Putty Knife or
Thin-blade Screwdriver

(Single Door Refrigerator Models only)

REMOVE THE
1
REFRIGERATOR DOOR
Tape the door shut with masking tape.
A
B
Remove the hinge cover on top of the
refrigerator door by squeezing it and
pulling it up.
C
Using a 3/8" or 10 mm socket
ratchet/driver, remove the bolts securing
the top hinge to the cabinet. Then lift the
hinge straight up to free the hinge pin
from the socket in the top of the door.
D
Remove the tape and tilt the door away
from the cabinet. Lift the door off the
center hinge pin. Ensure that the white
hinge pin thimble remains on the hinge pin
or inside door hinge pin hole located in the
bottom of the door.
E
Set the door on a non-scratching surface
with the inside up.
24
Hinge Cover
Top Hinge

Publicité

Table des Matières
loading

Table des Matières