GE 20 Série Manuel D'utilisation Et D'installation page 23

REPLACING THE FREEZER DRAWER
Two people may be required to complete
this procedure.
1 ATTACH AND SECURE THE
DRAWER FRONT TO THE SLIDES
A Pull out the rail assemblies to the full
length on each side of the cabinet.
B Locate the slots on the inside of the rail
assemblies near the back.
C Insert the hooks at the back of the
drawer railings into the slots on the rail
assemblies.
D
Lower the front of the drawer, making
sure the tabs on the sides of the railings
fit into the front slots in the rail assemblies.
Hook
Slot
Installation Instructions
Slot
Rail assembly
Tab
(on some models)
ATTACH AND SECURE THE
1
DRAWER FRONT TO THE SLIDES
(cont.)
Replace the Phillips head screws on both
E
rail assemblies.
REPLACE THE FREEZER BASKET
2
Replace the lower freezer basket by
lowering it into the frame.
23
Phillips
Screw