Removing The Freezer Drawer - GE 21 Manuel D'utilisation

REMOVING THE FREEZER DRAWER

The freezer drawer can be removed, if needed, to fit
through tight areas.
Read these instructions completely and carefully.
REMOVE THE BASKET
1
Open the freezer drawer until it stops.
A
Lift the freezer caddy up
B
C Pull the divider forward until the rear locating tabs
are out of the slots. Turn the divider slightly to the
side to release the front locating tabs and lift out.
The freezer basket rests on the metal slide
D
brackets and is held in place with swing locks.
Turn the swing locks from vertical to horizontal
E
position. Open refrigerator doors.
F
Lift the basket up and rotate it toward you.
Slide out from the side of the drawer.
REMOVE THE DRAWER FRONT FROM
2
THE SLIDES
A Remove the hex-head screw from each side
of the rail assembly.
B Tilt the drawer front toward the refrigerator
and lift out.
Rail
assembly
Screw
C Set the drawer front on a non-scratching
surface.
D Push the rail assemblies back into the cabinet.
Installation Instructions
.
(on some models)
TOP DRAWER
REMOVE THE BASKET
1
A
Open the freezer drawer until it stops.
Cut the 2 wire ties off of the basket with wire
B
cutters.
C Lift the front end of the basket so that the front
two alignment tabs come out of the metal slide
brackets first.
Then rotate the front edge of the drawer up
D
while lifting the remaining two rear alignment
tabs out of the metal slide brackets. Pull the
basket up and out of the drawer.
REMOVE THE DRAWER FRONT FROM
2
THE SLIDES
A
Remove the 8 hex head screws from the
drawer and remove the drawer.
Set the drawer front on a non-scratching
B
surface.
C
Push the rail assemblies back into the cabinet.
26
(on Double Drawer Models)