GE 21 Manuel D'utilisation page 22

INSTALLING THE REFRIGERATOR
CONNECTING THE REFRIGERATOR TO
1
THE HOUSE WATER LINE (cont.)
If you are using copper tubing, place a
A
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the GE SmartConnect
tubing, the nuts are already assembled to
the tubing.
If you are using copper tubing, insert
B
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the tubing,
tighten the fitting.
If you are using GE SmartConnect
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one additional
turn with a wrench. Overtightening may cause
leaks.
Fasten the tubing into the clamp provided to
C
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Icemaker-Ready models
Tubing
Clamp
1/4"
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection
SmartConnect
Tubing
Icemaker-Installed Models
Ferrule
Refrigerator
(sleeve)
Connection
SmartConnect
™
Tubing
Installation Instructions
™
tubing,
™
1/4" Copper
Tubing
™
1/4"
Compression
Nut
1/4" Tubing
Tubing Clamp
(cont.)
TURN ON THE WATER SUPPLY
2
(icemaker and dispenser models)
Turn the water on at the shut-off valve (house water
supply) and check for any leaks.
PLUG IN THE REFRIGERATOR
3
On models with an icemaker, before plugging in the
refrigerator, make sure the icemaker power switch is
set to the O (off) position.
See the grounding information attached to the power
cord.
PUT THE REFRIGERATOR IN PLACE
4
Move the refrigerator to its final location. Make sure
the back side of the refrigerator engages the anti-tip
bracket properly. The anti-tip floor bracket should
line up with the cutout in the back bottom of the
refrigerator, and fit through the cutout when the
refrigerator is pushed into position. (Refer to page 18,
Step 2A for more information.)
LEVEL THE REFRIGERATOR
5
Turn the front roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Use a 3/8 hex
wrench with extension, or an
adjustable wrench.
To adjust the rollers on 21
These models also have rear adjustable rollers
so you can align the refrigerator with your kitchen
cabinets. Use a 3/8 hex wrench with extension to turn
refrigerator, counterclockwise to lower it.
22
Roller adjusting screws
models:
' Counter Depth
clockwise to raise the