Step 3. Install The Refrigerator; Step 4 Remove The Freezer Drawer; Step 5 Remove The Fresh Food Doors - GE Monogram ZWE23P Instructions D'installation

STEP 3 INSTALL THE
REFRIGERATOR BEFORE
MOVING REFRIGERATOR
INDOORS
IMPORTANT:
Doors and passageways into the
installation location require a 31-1/4" min. opening. If
the opening is less than 31-1/4", the top cap, doors and
drawers must be removed. (See steps 4–6.)
NOTE: Skip steps 4–5 if door removal is not required.
Go to page 10, Move The Refrigerator.
NOTE: To prevent damage, leave inside
packaging, door spacer and outside protective
wrap in place until the unit is moved to the
installation location.
STEP 4 REMOVE THE FREEZER
DRAWER
The freezer drawer can be removed, if needed, to fit
through tight areas.
Read these instructions completely and carefully.
A. Pull the freezer door open to full extension.
B. Remove 3 attachment screws, located at the bottom
on each side of the freezer door using 3/8" hex
socket driver.
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to secure the
door before lifting.
ATTENTION
Avertissement de porte lourde.
La porte du compartiment congélateur est lourde. Utilisez
les deux mains pour stabiliser la porte avant de la soulever.
PRECAUCIÓN
Riesgo al levantar la puerta
La puerta del freezer es pesada. Use ambas manos para
asegurar la puerta antes de levantar la misma.
C. Lift the freezer door to disengage it from the slide
mechanism. The door can safely rest on the bot-
tom. Do not rest the door on any other surfaces to
avoid scratches. Push the slide mechanism back
completely until it self retracts.
Installation Instructions
STEP 5 REMOVE THE FRESH
FOOD DOORS
A. Securely tape the door shut with masking tape or
have a second person support the door.
B. Start with left-hand door first: Remove the hinge
cover on top of the left refrigerator door by removing
all hex screws and pulling it up. Do the same for the
right-hand door and the middle cover.
C. Disconnect both electrical connectors at the top
cover.
Remove the 1/4" hex head screw to disconnect the
ground wire from the hinge.
Remove the 1/4" hex head screw to remove the
strain relief from the water line.
Ground
screw
9
Hinge
Cover
Strain
Relief