Step 11 Connect Water Supply; Step 12. Plug In The Refrigerator; Step 13. Level The Refrigerator - GE Monogram ZWE23P Instructions D'installation

STEP 11 CONNECT WATER
SUPPLY
A cold water supply is required for automatic ice
maker operation. If there is not a cold water supply,
you will need to provide one. See Installing the Water
Line section.
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet.
• If your refrigerator does not have a water filter,
we recommend installing one if your water supply
has sand or particles that could clog the screen of
the refrigerator's water valve. Install it in the water
line near the refrigerator. If using SmartConnect ™
Refrigerator Tubing Kit, you will need an additional
tube (WX08X10002) to connect the filter. Do not
cut plastic tube to install filter.
• Before connecting the water line to the house,
purge the house line for at least 2 minutes.
A. If you are using copper tubing, place a
compression nut and ferrule (sleeve) onto the end
of the tubing coming from the house cold water
supply.
If you are using the SmartConnect ™ tubing, the
nuts are already assembled to the tubing.
SmartConnect ™
Tubing
Refrigerator
Connection
Installation Instructions
1/4"
Compression Nut
Ferrule
(sleeve)
OR
STEP 11 CONNECT WATER
SUPPLY (Cont.)
B. If you are using copper tubing, insert the end of
the tubing into the refrigerator connection, at the
back of the refrigerator, as far as possible. While
holding the tubing, tighten the fitting.
If you are using SmartConnect ™ tubing, insert
the molded end of the tubing into the refrigerator
connection, at the back of the refrigerator, and
tighten the compression nut until it is hand tight.
Then tighten one additional turn with a wrench.
Over tightening may cause leaks.
C. Fasten the tubing into the clamp provided to hold it
in position. You may need to pry open the clamp.
D. Turn on the water at the shut-off valve to check
for leaks.
STEP 12 PLUG IN THE
REFRIGERATOR
See the grounding information
attached to the power cord.
STEP 13 LEVEL THE
REFRIGERATOR
The leveling legs have two purposes:
• Leveling legs adjust so the refrigerator is firmly posi-
tioned on the floor and does not wobble.
• Leveling legs serve as a stabilizing brake
to hold the refrigerator securely in position during
operation and cleaning. The leveling legs also pre-
vent the refrigerator from tipping.
Turn the leveling legs clockwise to raise the refrigera-
tor, counterclockwise to lower it.
NOTICE:
damage, the leveling legs must be firmly
touching the floor.
13
Raise
Flat-Head Screwdriver
To avoid possible property