Philips Respironics SimplyGo Manuel De L'utilisateur page 44

On Arrival
When you arrive at your destination, check the status of your system's battery
This is an excellent time to recharge all batteries, so they're ready to go
when you need them The charge level on your batteries can be checked by
following the instructions in the Inserting and Removing the Battery section of
this manual If a battery requires charging, this can be done as described in
the Charging the Battery with the AC Power Supply section of this manual
If you have any questions or concerns about traveling with your SimplyGo
system, contact your home care provider
Specications
Operating
Conditions
Storage and Transport
Conditions
SimplyGo Oxygen Concentrator
Oxygen
Concentration*
Breathing Frequency
Inspiratory Trigger
Sensitivity
User Interface
Dimensions
Weight
Sound Level**
Operational temperature:
41° F to 104° F (5° C to 40° C)
Relative humidity: 15% to 95%
Altitude: 0 to 10,000 ft (3048 m)
Atmospheric Pressure: 70 kPa to 101 kPa
-4° F to 140° F (-20° C to 60° C) - unit only
(Note: Refer to the Battery Storage section of this
manual)
Relative humidity: up to 95%, non condensing
90% +6%/- 3% at all settings
Up to 40 BPM
≤ 03 cm H
O in Pulse Mode
2
≤ 02 cm H
O in Sleep Mode
2
Push buttons, back-lit liquid crystal display (LCD)
115 in x 10 in x 6 in (292 cm x 254 cm x 152 cm)
100 lbs (454 kg) with battery installed
43 dBA typical at Nominal Pulse Mode Setting of 2
and 20 BPM
(when measured at 39 in (1m) from front of device)
SimplyGo User Manual
41