Philips Respironics SimplyGo Manuel De L'utilisateur page 18

Charging the Battery with the AC Power Supply
Important: The rst time you charge the battery, be sure to charge it fully Do
not use the DC power cord to do so; instead use AC power
Note: The battery will begin charging whenever you connect the device to an
AC outlet, whether or not you are operating the device
To charge the battery using the AC Power Cord provided with your system,
follow these steps
1 Connect the AC Power Supply's output cable to the SimplyGo power
input connector
2 Connect the AC Power Cord's connector into the AC power supply
3 Connect the AC Power Cord's plug into an AC outlet installed to meet
national or regional electrical code
Note: As soon as you connect the device to an energized AC power source,
the light on the AC Power Supply lights up The cooling fan will turn on
when the battery begins to charge This is normal The fan will run the
entire time it is charging to keep the battery cool
4 When charging is complete (this takes four hours or less), disconnect the
AC Power Supply and store it with the AC Power Cord for future use
Note: Replacement and spare batteries are available separately For
information, contact your home care provider
Note: An optional SimplyGo Smart Battery Charger/Recalibrator (sold
separately) is available for your system For more information, contact
your home care provider
SimplyGo User Manual
Indicates Battery Level
Indicates Charging
15