Replacing The Side Brushes; Storage - DS Produkte VR301 Mode D'emploi

EN
1. Fold the handle on the dust bin (1) up and use it to pull the dust bin (2) out of the
device.
2. Open the dust bin (2) by folding the catch forward and pushing it up.
3. Empty the dust bin (2) into a waste bin.
4. You should also clean the HEPA and dust fi lter after every use. They are located in
the dust bin (2).
5. Release both catches on the side and take the dust fi lter off of the HEPA fi lter.
6. Empty out any coarse dirt over a waste bin.
7. Insert both fi lters again. When inserting the fi lters, make sure that they are
properly secured!
8. If necessary, clean the dust bin (2) with clean, warm water. Then let it dry completely
before putting it back in the device.When putting it back in the device, make sure
that the dust bin (2) is properly seated in the dust bin compartment and that
the handle (1) is folded down.

Replacing the side brushes

If the side brushes (7) are worn, they must be replaced. Two spare side brushes are
contained in the product contents.
1. Remove any coarse dirt from the bottom side of the device.
2. Place the device upside down on the ground or a table.
3. Pull the side brushes (7) off of the axles.
4. If necessary, clean the brush compartments.
5. Place the new side brushes (7) on the axles. They must audibly lock into place.

Storage

• Store the device and accessories in a cool, dry place that is out of the sun and out
of the reach of children and animals.
• Take the batteries out of the remote control if you do not use the device for a
prolonged period of time.
32