Functions; Timer Function - DS Produkte VR301 Mode D'emploi

Functions

The device has three different vacuuming modes. You can use the menu button on the
device or the corresponding buttons on the remote control to select these modes.
You can also use the directional buttons to steer the robotic vacuum cleaner manually.
In each mode, the device will vacuum until the rechargeable battery is low. It will then
automatically locate the charging station.
The robotic vacuum cleaner has the following vacuuming modes:
Random cleaning mode: The robotic vacuum cleaner will travel straight
ahead until it encounters an obstacle, it will then veer off and travel straight
ahead in another direction.
Spiral cleaning mode: The robotic vacuum cleaner will begin by travelling
from the inside to the outside in an increasingly large spiral. It will then
travel from the outside inward in an increasingly small spiral. Once it has
reached its starting position, it will look for a new area and begin the pro-
cess again.
Edge cleaning mode: The robotic vacuum cleaner will move forward until it
encounters an edge (e.g. wall, piece of furniture), it will then travel along this
edge until it reaches the next edge.

Timer function

– If you do not deactivate the timer and the device is charged, it will always start
cleaning at the set time.
– The device will vacuum in random mode with the timer function.
You can program the robotic vacuum cleaner so that it starts vacuuming at a desired
time.
1. With the start/pause switch (6) on the device, switch the device to standby mode.
2. Push the button on the remote control to set the time at which you wish the
device to vacuum each day.
3. A signal tone will sound, the start/pause switch (6) will illuminate in red and the
device will start vacuuming.
4. If you now switch the device to standby outside of the timer setting, the start/pause
switch (6) will illuminate in red.
5. To deactivate the timer, switch the device to standby mode and push the
on the remote control again. The timer has now been deactivated and the start/
pause switch (6) will illuminate in blue.
29 EN
button