DS Produkte VR301 Mode D'emploi page 27

Fitting the side brushes
1. Place the device upside down on the ground or a table.
2. Fit the side brush (7) marked with R on the receptacle on the device that is marked
with R.
3. Fit the side brush (7) marked with L on the receptacle on the device that is marked
with L.
4. The side brushes (7) must audibly lock into place.
Set up the charging station
17
16
ATTENTION!
■ Do not leave the mains adapter connected for a prolonged period of time. After every
charge operation, disconnect it from the mains unless you have confi gured the timer
to automatically start the device.
■ Keep the charging station and device away from radiators, other heat sources and
direct sunlight.
■ The charging contacts on the device (13) and on the charging station (16) should
always be free of dust and clean so that the rechargeable battery can be charged.
Therefore, wipe it off regularly with a soft, dry cloth.
1. Place the charging station on a clean, level fl oor with the back towards a wall
near a socket. When selecting the location, keep in mind that once it has fi nished
cleaning, the robotic vacuum cleaner must have an unobstructed path back to the
charging station. There must be approx. 1.5 to 2 m of free space in front of the
charging station; there should be no furniture or other obstacles within this space.
The sensor (17) must not be covered. No refl ective objects (e.g. mirrors) should be
behind or next to the charging station as they could confuse the sensor (17).
2. Connect the mains adapter cord to the charging station and then insert the mains
plug of the mains adapter into an easily accessible socket. Make sure that none of
the leftover cord is located in front of the charging station so that the device
is not obstructed when docking and that the cord does not pose a tripping hazard!
27
14 Indicator light
15 Connection for the mains
14
plug
16 Charging contacts
17 Sensor
15
16
EN