Sony MFM-HT75W Mode D'emploi page 773

3 Press the M/m buttons to select "Fine Tuning" and
press the OK button.
4 Press the M/m buttons to fine-tune the picture and
press the OK button.
5 Press the MENU button to exit the menu screen.
Changing TV channels
Select either mode for channel selection.
In "Direct" mode, you can select a channel by pressing a channel
number button on the remote control. The channel previously
assigned to the button will be selected. (You can assign up to 12
channels to the buttons.)
In "Ten-Key" mode, you can select a channel by inputting the
channel number using the channel number buttons. You have to
enter the first digit (of the channel number) first, and then the
second digit. Press the 10/0 button to enter "0." Press the 12/
button to set your entry.
To select "Channel 14"
To select "Channel 20"
Tip
• You can change channels by pressing CH +/– buttons on the display or
(Channel) +/– buttons on the remote control.
• If you do not press 12/ button after inputting the channel number,
it takes about 3 seconds to go to the channel. Press 12/
go to the channel quickly.
1 Press the MENU button.
2 Press the M/m buttons to select
press the OK button.
The "Channel" menu appears on the screen.
3 Press the M/m buttons to select "Channel
4 Press the M/m buttons to select the desired mode
5 Press the MENU button to exit the menu screen.
Setting up channels to be selected using the
Selection" is set to "Ten-Key")
You can set up TV channels selected by pressing the
unbroadcasted or unnecessary channels.
1 Press the MENU button.
2 Press the M/m buttons to select
3 Check that "Channel Selection" is set to "Ten-Key."
4 Press the M/m buttons to select "Channel Setting"
5 Press the M/m buttons to select a channel for
6 Press the M/m buttons to select "Add" for the
button to
(Channel) and
7
Selection" and press the OK button.
The "Channel Selection" menu appears on the screen.
and press the OK button.
• Direct:
Selects "Direct" mode.
• Ten-Key: Selects "Ten-Key" mode.
(Channel) +/– buttons (When "Channel
(Channel) +/– buttons. You can also skip
press the OK button.
and press the OK button.
setting and press the OK button.
channel to receive, "- -" to skip and press the OK
button.
Repeat Step5 and 6 for all the channels.
Press the MENU button to exit the menu screen.
(Channel) and
17